Drill from both sides rather than trying to drill straight through. It was difficult to open with the existing door handle! It is similar to remote door unlock but the door pops open. Although you can put the solenoid just about anywhere you want by using sliding door pulleys that can be found at any hardware store. The glass set up may not be fun but don't put the cart before the horse. The pull cable from the solenoid is routed through the door metal by a bicycle brake cable more on this later! Now I can remotely open the door like magic.
Need help with shaved door handles! - Car Forums and Automotive Chat
The solenoid is mounted with 4 bolts at the bottom. Running electrical wiring I tie-wrapped the wires at the solenoid to the solenoid to keep them out of the way of the window regulator and then routed them up to the top door hinge. I used a cable clamp to make sure that the cable bent at a gradual angle. I threaded the original latch opening for the door handle pull rod to fit a hex head screw and used a locking nut on the other side.
Need help with shaved door handles! One of the tricky parts of building is the door glass so here is some guidance from Pete Hagan. Sold in pairs one pair completes one door and covered by a lifetime warranty. These pulleys are about 1" in diameter, but you will need to make a cover to keep the cable from sliding off. Eliminate the hassle and install Hagans on your next project.
The slot is positioned so that when you pull on the door handle rod like when opening the door , it immediately pulls the latch. The solenoid electronically takes the place of the door handle. Solenoid Installation I installed the solenoid in a convenient place, in the bottom of the door in the access opening. Replace worn or missing felt channel. If you try to drill straight through from one side only, you'll break the drill bit when it goes through into the hex opening guess how I know! It's going to supply the vertical channel that the glass slides up and down in.